Vinyl Banners

Sign Stand Supplier Australia
Sign printing machineBanner Stands are simple to change over for new printing and panels. The unique and fast system means that you can update your advertising panel in minutes.

Using a key to undo the top section, the portable material is slid away from the railing. Special tape is used to secure the material to the top. This can be reused. The lower sections have a printed instruction manual to help.

Lift up the banner, insert a pin and change your signage quickly.

Spring Tension is what holds the panel into place, the rear side pole extends to the hold and upright banner stand.

To renew your sign, undo the top railing section, insert a small key found in the right side end capping or underside. Unwind the entire length of panel, then, The small right angle key goes into the small hole to prevent retraction.

 

Then, with the panel extended and the key inserted to restrict self winding back into the stand, remove the special covering tape and lift away from the sticky tape. This sticky tape can be reused or overlaid. Press down the new signage onto the tape, and use an additional tape to stop any edge lift. Remove the key from the stop hole and let the system retract back into the banner stand.

fast signs and banners

Undoing a banner stand for the new signs

Different models use different top rails, undo the banner sign from the railing and change or remove the flexible panel. At the bottom, you have some left and right room for adjustment. Also, the panel will spring into the system fast if not controlled. Carefully and slowly let the sign wind into the unit as evenly and straight as possible.

Quick Changing Banner Stand and Sign systems for shop displays with photos.